CAN-CR210/FO
Stackable converter from ISO/IS 11898-2 to fiber optic cable
The CAN-CR210/FO is used for the conversion of the CAN signal from copper wire (ISO/IS 11898-2) to fiber optic cables. This allows complete isolation and protection against EM-influences to be achieved. For creating star or tree topologies, several CAN-CR210/FO can be connected to a CAN-hub via the integrated backbone bus (also in conjunction with CAN-CR200).
One special feature of the repeater is, that it can separate a defective segment from the rest of the network, so that the remaining network can continue working. After elimination of the defect, the segment is switched into the network again.
Technical Data
| Display | Transmit and defective segment (three duo LEDs), Power (one LED) |
| CAN bus interface | ISO/IS 11898-2, galvanic isolated, Sub-D9 connector (CAN-High, CAN-Low, CAN-GND). CAN termination resistors are integrated (can be disabled). Integrated backbone bus. |
| FOC connection | 2 x F-SMA or ST terminal for duplex line (Glass 50/125 µm duplex) |
| Baudrate | Up to 888 kbps |
Delay |
~300 ns (translates into ~60 m (~90ft.) bus length) between the wire connection of a FO Repeater through the fiber optic cable to the wire connection of a second FO Repeater (not including the signal delay time of the fiber optics between the two repeaters, which is ~5 ns/m) |
| Power supply | 9 - 32 V DC, 3 W typ., through terminals |
| Temperature range | -20 ºC ... +70 ºC |
| Housing, size | Plastic enclosure, 22.5 x 100 x 115 mm (without FO connector) |
Contents of delivery
- CAN-CR210/FO, Quick reference
Accessories
- T bus connector for creating star / tree topologies
|